Latest Update: 2026/07/09

The below log shows all updates for this product since release:

v2.1.0 - 2026/07/08

Built on 8 July 2026

- [Systems] Fixed bugs with the auxiliary fuel pumps logic.

- [Systems] Fixed a bug where the engines were starting with all electric pumps turned off, due to the engine-driven pumps being always on.

- [Systems] Fixed Autopilot logic and parameters, addressing an issue where the roll commands were not correctly working with the Working Title’s GNS selected.

- [Systems] Fixed COM/NAV duplication issue occurred with the Working Title’s GNS 530 & 430 integration. The GNS430 now correctly takes COM/NAV 2 as it should.

- [Systems] Fixed altimeter auto-setting to current QNH when starting in Cold & Dark, now setting to standard pressure (29.92 inHg / 1013 mb) by default in this FLT scenario.

- [Systems] Fixed battery temperature calculation, where it was incorrectly indicating an overheating condition under certain conditions.

- [Powerplant] Fixed some engine parameters regarding performance, thrust and propellers’ configuration, matching the values from the POH.

- [Model Behaviors] Fixed elevator trim sensitivity after a bug with the yoke’s switch button logic.

- [Model Behaviors] Fixed elevator trim wheel interaction logic not working correctly when interacting with the console’s controller.

- [Model Behaviors] Fixed reversed parking brake lever positions. This is a regression to the behavior correctly exhibited in the MSFS 2020 product.

- [Model Behaviors] Fixed condition levers position when starting the flight in Cold & Dark, where they were always in LO IDLE instead of being in the FUEL CUTOFF position as expected.

- [Model Behaviors] Ignition indicators are now clickable, emulating the testing functionality before engine start, as described in the POH.

- [Model Behaviors] Fixed self-preparing for departure logic now being triggered only if the respective setting on the EFB is enabled, and also if the parking brake is released and the wheel chocks are removed.

- [Model Behaviors] Fixed sunshades logic.

- [Artwork] Fixed propeller cone becoming translucent in motion under certain conditions.

- [Artwork] Fixed a flickering bug on the propellers when the engines were either turned off or operating at lower RPM regimes.

- [Artwork] Fixed EFB tablet location on the cockpit’s 3D model to prevent clashing with the cockpit’s openable side (small) windows.

- [Artwork] Fixed flickering with the registration decal on the fuselage.

- [Flight Dynamics] Fixed landing gear damping ratio to make the shock absorbers less rigid and a bit bouncier.

- [Preflight] Fixed a bug where the rear doors on 110P1/110P2 variants unexpectedly closed by moving the pilot avatar a few steps back from the aforementioned door.

- [EFB] Added a toggle to fully disable the automatic self-preparation for departure (or invalid state warning) logic inherited from the MSFS 2020 product. This feature is now disabled by default.

- [EFB] Fixed a bug where the passenger, luggage & cargo payload values were not correctly parsed nor updated on the GUI when importing the data from the SimBrief OFP.

- [EFB] Fixed EFB logic where the SimBrief OFP import failed when there was no alternate airport assigned in the flight plan.

- [EFB] Fixed alternate button logic on METAR and Charts, as part of the bug where there was no alternate airport on the SimBrief OFP.

- [EFB] The selected GPS model dropdown is now disabled if none of the supported third-party GPS is installed on the system.

- [EFB] Fixed the logic of the “Show VR Icon when on VR Mode” setting not correctly working as intended.

- [EFB] Removed a JS library which was included among the product but never actually called on code, and reorganized calls to minified versions (if available) of the CSS/JS libraries and dependencies used on the product.

- [EFB] The fuel total card, where it shows the sum of fuel quantity from both tanks, now reads “Total (L + R)” instead of just “Total”, avoiding possible misunderstanding.

- [EFB / Systems] Improved reliability of communications between the EFB instrument and WASM, especially when reading & saving settings.

- [VFS] Removed some JS-related files that were not supposed to be included in the final package.

- [VFS] Reduced final package’s storage footprint, passing from 18.8GB down to 16.1GB (uncompressed).

- [Docs & Tutorials] Updated user manual and added a log of revisions section at the beginning of the product’s operation manual, in order to highlight all important revisions made.

- [General] Other minor bugfixes.

v2 

- Release version

The product download in your account is updated as and when updates are released, so if purchasing after any of the given dates your product will include all updates prior to that date.

To download updates you will need to re-download the product from the 'Your Orders' section of your account which you can log into by clicking here.

For guidance on downloading this update, please visit this FAQ.