Latest Update: 2023/03/20
The below log shows all updates for this product since release:
v1.025
Systems
- PCU System: PEC lights will come up on overspeed >1060
- PCU System: After engine failure with prop unfeathered, rpm will slowly drop to 400 (IAS dependent)
- Oil System: When alt feather pump is activated, the system will not delay the feathering due to oil pressure
- FADEC System: Fixed the PEC failure detection due to overspeed
- C&L system: ELEVATOR FEEL will light when all 3 systems power the elevators
- C&L system: Master warning will blink with C/L test
- C&L system: No more FADEC caution light when the engine failure externally triggered
- C&L system: Caution lights will go out faster after N3 hydraulic system test completed
- Navigation system: Allow Back Course for the same ILS/LOC frequency for both runways, when the flight sim scenery has correct nav aids.
- Flight Dynamics: Fixed the problem with aircraft crash or going underground when positioned on some airports
- Added EDP failure to the POWERPLANT page
FMS
- Corrections to linking logic between the Leg types
- Various improvements of STAR/IAP linking logic
- Re-design of the VNAV logic and the FAF identification logic • Re-design of the altitude calculations for VNAV
- Flight plan pages: ETE/ETA and altitude will not be shown on some legs where it can not be calculated
- Fixed incorrect holding entry type detection
- FPL arrive / FPL depart pages will insert the procedure when FPL key is pressed
- Added RAIM error factor gpsRAIMErrorFactor as a multiplier 0.0 to 1.0 to mjc84.ini file
Instruments
- Improved clock night lighting in VC
- PFD: AP inhibit is no longer indicating in place of AP Disengaged
- MFD: No longer 2 different holding patterns shown for a single holding
- Standby: fixed baro hint
- Fixed the TX/RX indication link to the vatsim/ivao clients
Interface
- EFIS config data is sent over the network
- Main gear blown tyre on touchdown will not be simulated with WearOffFactor=0.0 mjc84.ini file entry
- Force Feedback outputs will be provided with ElevatorInFSXmode = 0 mjc84.ini file entry
- Introduced new variable elevatorTrimFromFsx in mjc84.ini to control the elevator trim directly via a variable
- mjc84.ini (Flight Controls): Added the trim factor setting
- Oil System: Introduced failures EDP_failed[0][1] variable
- FD type added to the interface to be synchronized between the Q400 and the EFIS application
- PEC System: published the PEC failure variable
- Docs (Joystick connector) : published FLIP operator in connector description
v1.024 - 2022/02/02
- fix to the copy protection algorithm, which eliminates the protection experienced by users of the new Intel Gen12 CPU
- Minor Fixes
The product download in your account is updated as and when updates are released, so if purchasing after any of the given dates your product will include all updates prior to that date.
To download updates you will need to re-download the product from the 'Your Orders' section of your account which you can log into by clicking here.
For guidance on downloading this update, please visit this FAQ.